A tankless water heater heats water on demand. When a tap opens, a gas burner or electric element fires and heats the stream. Call (385) 488-1892 to talk through whether it suits your house. The same line handles emergencies 24/7 if your current tank fails first.
What tankless does well
No standby tank
Nothing sits hot all day, so there is no tank to rust through and no large volume to flood a floor.
Steady supply
Hot water keeps coming while the burner runs, up to the unit flow rating.
Wall mounting
The unit hangs on a wall and frees floor space in a garage or closet.
Long service life
With care, tankless units are commonly rated to last longer than tanks.
What it asks of the house
| Item | Why it matters | What we check |
|---|---|---|
| Gas line size | A tankless gas unit burns a lot of fuel at once | Pipe diameter, length and meter capacity |
| Venting | Combustion gases must leave safely | Vent material, route and clearances |
| Flow demand | The unit has a maximum flow at a temperature rise | Number of fixtures running at once |
| Incoming water temperature | Colder water takes more energy to heat | Winter inlet temperature in Draper |
| Water hardness | Scale clogs the heat exchanger | Softener or a descaling plan |
Draper winters and hard water
Draper sits at about 4,751 feet and gets snow from November to March, so winter inlet water is cold. The temperature rise the heater must deliver can be higher in January than in July, and a unit that is fine in summer can struggle when two showers run in winter. We size to the winter number.
Draper City's water quality report shows total hardness from 16 to 357 mg/L. Scale builds up on a tankless heat exchanger and cuts efficiency. Plan for an annual descaling flush and, where your water is on the hard end, a softener. The name on your water bill tells you which utility to ask: the Utah Division of Water Resources describes Draper City service as generally west of I-15 and south of 14600 S.
Want a tankless estimate?
Call to book a site visit. We check the gas line, vent and demand.
Installing a tankless heater
Survey
We look at the gas line, vent path, electrical supply and wall location.
Size
We calculate flow and temperature rise for your fixtures and incoming water.
Install
Wall-mount, connect water and gas, run the vent and add isolation valves for flushing.
Commission
We test combustion, set temperature and show you the maintenance valves.
If you only want the tank swapped, see water heater replacement. For installation of a standard unit, see water heater installation.
What changes the price of tankless installation
Insurance rarely pays for an upgrade. Check whether your utility or manufacturer offers rebates. Want your real number? Call (385) 488-1892.
Sources and standards behind this page
Venting, gas and water connections for tankless units follow the International Plumbing Code (IPC) as amended by the Utah State Construction Code in Utah Code Title 15A and the manufacturer's installation instructions. Winter inlet temperature and hardness notes draw on Draper's elevation and Draper City's 2022 water quality report.
Straight Answers
Yes. The line at (385) 488-1892 is staffed 24/7. If your existing tank fails, we can handle the emergency first and plan tankless later.
It heats continuously up to its flow limit. Run too many fixtures at once and the unit may not keep up. Correct sizing avoids that.
Yes. Flushing the heat exchanger once a year removes scale, which is more important with hard water.
Often. It depends on gas line capacity, venting and wall space. We survey the house first.
Yes, but colder incoming water means the unit must raise the temperature more, which reduces maximum flow. Size for winter.
It can be, especially where floor space is tight or standby heat loss matters. We compare costs honestly and tell you if a tank fits better.
