Serving Draper, UT and nearby towns
Open 24/7 · (385) 488-1892
Tank water heater on a concrete platform in a garage, held in place with metal straps
Home / Services / Water Heater Installation

Water Heater Installation in Draper, UT

Whether you are finishing a basement, moving the heater or upgrading before the old one fails, a planned installation lets you pick the unit, the location and the details.

Clear price before work startsSame-day appointments when available
Talk to a plumber
(385) 488-1892
Call Now

A planned water heater installation gives you time to make good choices. Call (385) 488-1892 to talk through the job. We schedule installs for new construction, remodels and upgrades, and the same line takes emergency calls 24/7 if a heater fails first.

Where a water heater should go

Location drives cost. A garage or utility room with a floor drain is the easiest. Attics and finished closets need a pan with a drain that runs somewhere sensible, access for service and, for gas, correct venting. Utah amendments to the plumbing code require the pan drain to be trapped and vented and treat the pan as an emergency receptor, so plan its route early.

What an installation includes

Site check

We confirm fuel, space, venting, circuit or gas supply and where the relief line will discharge.

Set and secure

The tank is placed on a stable base and strapped as Utah rules require.

Connect

Water lines, shutoff valves, relief valve, discharge piping and, for gas, a tested gas connection and vent.

Test and explain

We fill, purge, light or energize the heater, set temperature and show you the shutoff valves.

Gas, electric or tankless

Tank heater

  • Lower upfront cost
  • Stores hot water, so a large household may need a big tank
  • Takes floor space and needs a drain pan
  • Replaces in about a day

Tankless heater

  • Hot water on demand and no standby loss
  • Higher purchase and install cost
  • Needs adequate gas line or power and venting
  • See tankless water heaters

Backflow, expansion and pressure

Utah requires backflow assemblies to be tested at installation or within ten days and annually after that by a Utah certified tester. If your new heater is part of a system with a backflow device, thermal expansion can raise pressure.

An expansion tank handles it. Draper City says its supply area has no lead service lines, and it also warns that unprotected hoses and sprinklers can create cross-connections, so ask us about any hose bib near the heater.

Ready to book an install?

Call to pick a day. We confirm the details by phone first.

Call (385) 488-1892

Planning for Draper homes

Homes in the hills of east Draper may sit in a pressurized upper zone, while valley homes run at lower pressure. A pressure gauge on a hose bib tells you which you have, and the answer affects whether you need a regulator and an expansion tank. Hard water is another planning point, since Draper City reports up to 357 mg/L total hardness at some sources. A softener installed ahead of the new heater protects it.

If the old heater has already failed, you may be better served by the replacement page. If it is only acting up, see repair.

What changes the price of a water heater installation

Type and capacityTank size, fuel and efficiency class set the equipment cost.
Venting and gasA new vent run or gas line upsizing adds labor.
LocationMoving the heater means new water, gas or electrical runs.
Code add-onsPan, drain, straps, expansion tank and relief piping.
PermitAsk the Draper Building Division, (801) 576-6399, what your job needs.

Installations are rarely covered by insurance unless they follow a covered loss. Want your real number? Call (385) 488-1892 and describe the space.

Sources and standards behind this page

Planning notes on pans, straps and backflow come from the International Plumbing Code (IPC) as amended by the Utah State Construction Code in Utah Code Title 15A. Backflow assemblies must be tested at installation or within ten days and then yearly by a Utah certified tester. Draper City states its supply area has no lead service lines.

Straight Answers

Yes. Call (385) 488-1892 and we set a window. For new construction and remodels, we coordinate with your schedule.

Yes. The same line takes emergency calls any hour. If your heater fails, we can switch from a planned install to the faster replacement visit.

Often yes. It depends on venting, water and gas or electric routing and drain access. We assess it on a site visit.

Water heater work often requires one. Ask the Draper Building Division at (801) 576-6399 and we will tell you what the inspector may look for.

It is a metal strap that holds the tank in place during movement. Utah amendments to the plumbing code require water heaters to be anchored or strapped.

Look at what you already have, the cost of each fuel where you live and the venting available. Gas heaters often recover faster, and electric units are simpler to install. We lay out both options when we visit.

Ready To Book Water Heater Installation?

Call (385) 488-1892. A dispatcher answers 24 hours a day.

☎ Call (385) 488-1892

Our Draper, UT Service Area

Dispatch runs from Draper and covers Draper, Riverton, Sandy, South Jordan and Herriman along the south end of the Salt Lake Valley. Call (385) 488-1892 any hour to confirm your address is in range.

☎ Call (385) 488-1892 · 24/7